|
Q1. How can you reset the BIUT printer (or a printer from a different ATSI product for use with the BUIT tester)?
Q1. How can you reset the printer from a different ATSI product for use with the BUIT tester?
A:Instructions for Setting Mini Printer Default Settings
If you have the original manual for the Mini Printer the directions for changing printer settings are on page 14. If you do not have the original manual please follow the directions below:
1.Unplug the Printer Power Cable.
2.Press and hold down the left side of the rocker switch and plug in the printer. The printer will advance the paper. After the paper advance has stopped, count for 3 to 5 seconds and then release the switch.
If this step was completed successfully the printer will print "Setup Menu Configure"
If the printer prints "Ready" try step 2 again
3.After step 2 is accomplished and the printer has printed "...Configure":
Press the rocker switch to the right to enter the configuration menu.
4.After you have entered the configuration menu the printer will print "Load Defaults". Press the rocker switch to the right to load the defaults.
5.After all the above steps have been completed you can run the auto printer config on your BIUT Tester.
If you have any questions Please Call ATSI
|
